Say goodbye to the guesswork and hello to a flawless fit every time.
Tools and Materials Needed:
- Measuring tape
- Painter’s tape
Step-by-Step Guide
Step 1: Gather Materials
Grab a measuring tape and some painter’s tape.
Step 2: Mark the Strip Locations
✅ Front Strips: Apply painter’s tape along the front bumper, about 2 inches from the edge. Follow the bumper’s curve to line up where the strips will sit.
✅ Side Strips: Place tape along the sides, also 2 inches from the edge, for even lighting coverage.
✅ Rear Strips: Run a strip of tape around the rear bumper. Adjust as needed if you’ve got custom modifications.
Step 3: Remove the Tape
Carefully peel off the tape from each section—for your measurements.
Step 4: Measure the Tape
Using the measuring tape, measure each piece you just removed. This is your guide to the exact size you need.
Step 5: Record Your Measurements
Divide the front and rear measurements by two to get your final LED strip sizes. Write down these sizes to reference when ordering.
With the Painter’s Tape Method, you’re now equipped for a seamless, simple install.
Now your ready to order your Perfect-Fit Underglow Kit!